Forums
| South Coast New MINI Club :: Forums :: Technical :: Performance |
|
<< Previous thread | Next thread >> |
| 30-70mph 3rd gear times | ||
| Go to page >> | |
|
Moderators: Dave, cooper_sport, Neil the Hat, BlackFerret
|
| Author | Post | ||
| Dave |
| ||
   Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Hey Guys, Please can people post up your 30-70mph times in 3rd gear with a basic spec/HP of your MINI. I'm very interested to see how everyone compares as this will test low end/mid range torque which is what we really use everyday instead of outright drag stripe HP. The idea is to read dead on 30mph and then floor it to 70mph. These can easily be taken on any straight flat piece of national speed limit road with a stop watch and using the OBC read out. Please no slip roads as it can be dangerous and most of them either go up or down hill. Mine was taken from the average of 4 runs rather than the fastest: GTT 230+ with a couple of extra mods - 6.2seconds Thanks gb means GearBox.. Current Standings: Cooper S: Tuls : 4.62 (04gb, TwinCharge 400HP) roland2003 : 4.85 (GTT300T, head and cams) Snowie : 5.1 (06gb, GP + mods) 1320autos : 5.2 (05gb, 17% pulley,manifold, JCW Injectors) BigShow : 5.6 (03gb, 180hp+, manifold) roland2003 : 5.7 (customers 05gb, GTT220, GRS Intercooler, GTT Manifold) BRMcooper : 5.7 (05gb, 15%, manifold) MINI-Morgan : 5.77 (05gb, GTT230, manifold) lucachiarelli : 5.84 (06gb, 15%, gtt manifold+intercooler , crank) Cooper_Sport : 5.86 (05gb, 17% / GTT220, GRS intercooler) k m s: 5.94 (05gb, GTT220, manifold, intercooler, injectors) Jaw_F430 : 6.05 (05gb,15%,Bigger I/C +other mods) Edenalig : 6.15 (02gb, 15%, MTH, Alta CAI, Manifold, Miltek) MiniPetrolHead : 6.1 (05gb) sam_a156 : 6.2(05gb, JCW, manifold, +3% Crank, intercooler) Fisher: 6.35 (02gb, cams) Miss Lottie: 6.4 (R56 Stock) Aberdeen Al : 6.9 (03gb, GTT220, intercooler, manifold) beatbox : 7.05 (04gb, JCW210, intercooler) Hyper Active: 7.17 (05gb, lightwheels but stock) Cooper: minicabrio : 9.2 One Jaw_F430: 13.13 (R56 One) [ Edited Thu May 29 2008, 12:02PM ] MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Update on myself: Just finished off a night of testing and the rest of my tank of petrol too!! Yes the last runs were with the red light on but compared to the 1/4 of a tank times its not any different. 6degrees C outside and i've added a MiniMania 4-2-1 manifold with decat for these runs. Really need to get on the dyno to see what HP I am running these days... should be around 240bhp.... 30-70mph times: 5.7 5.8 5.8 Average 5.7s 30-70mph uphill sliproad: 6.2 6.2 6.3 Average 6.23 30-67mph(Think thats right... hit the rev limit every time!) 3.5 3.6 3.6 Average 3.57 I data logged the whole thing so when I get the time and the will to do it i'll see what the ecu said my max speed was in second and see what my boost pressure was. p.s. had a quick look....and for the 30-70mph times... Timing angle varies between -20 and 50 degrees! Can that be right? Intake pressure(T-MAP) ran between -13.07PSI and 18.16PSI. Not bad and didnt even reach the redline. 30-64mph (thats the rough speed I can see in the logs) Timing : -14 to 50 degrees Boost : -13.36 to 17.29PSI P.s.s just checked the maps and 50degrees is the limit for the face lift map... MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| HyperActive |
| ||
  Registered Member #27 Joined: Mon Jan 16 2006, 12:00AMLocation: Watford, Herts. Posts: 1130 | Here's my first effort, i've posted this up on mini2, and now here. What do you think Dave ?. I managed a 30-70 time of 7.17 sec with a stopwatch. This was just 1 run though, so i will need to do a few more runs to make sure this time is correct. My MCS is an 05 model, it has no engine mods, but i do have O.Z. Racing Ultraleggera 17" wheels on it but still use the stock tyre size of 205/45-17. The fuel tank was at least 3/4 full, tyre pressure around 33 psi and it was just me in the car. Air temp was around 10'C. Was this a good time for a standard 05 MCS, or not ?. | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Well you arent far of an 04 JCW  MAybe try a few more runs as you might get it faster too.... an average of 3 runs is a good idea. MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| HyperActive |
| ||
| Registered Member #27 Joined: Mon Jan 16 2006, 12:00AMLocation: Watford, Herts. Posts: 1130 | Did another run today Dave. This time i managed 7.39 seconds, so my average is going upto 7.28 sec. | ||
| Back to top | | ||
| Miss Lottie |
| ||
Miss Lottie, Miss GP, GP0235 who knows!! Registered Member #267 Joined: Sat Sep 23 2006, 11:00PMLocation: Bournemouth Posts: 884 | I did
several runs on a straight road in both cars: My 07 R56 Cooper S 6.4 seconds 6.4 seconds 6.4 seconds My car has 17" webspokes - i will check the tyres later. JCW 57 R56 Cooper S: 7.3 seconds 6.8 seconds 6.8 seconds The JCW had 18" R109 (lightweight) alloys - i am not sure about tyres. They would be standard MINI ones, whatever they are. | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Nice Time Lottie!  Poor JCW didnt do too well though.... maybe a few more miles will do it some good.Certainly shows the pace of a standard R56 MCS! MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| cooper_sport |
| ||
and my flaming MINI  Registered Member #7 Joined: Mon Oct 03 2005, 11:00PMLocation: Bournemouth Posts: 1741 | Just went for a run in my MINI and thought I would see what times I could get. My MINI has the GTT220 with reroute pipe. All of Rolands strut braces. 215/40 R17 Nankangs with after market alloys. Just under 3/4 tank of fuel Outside temp 10c Roads mainly dry with a little bit of damp. 6.4 6.3 6.4 6.2 6.3 So average is around 6.32 I also had the rear seats removed which should counter act the weight of my sunroof.  [ Edited Tue Nov 27 2007, 10:34PM ] | ||
| Back to top | | ||
| HyperActive |
| ||
| Registered Member #27 Joined: Mon Jan 16 2006, 12:00AMLocation: Watford, Herts. Posts: 1130 | Ok, i now have an average over 4 runs. 7.17 7.30 7.39 7.52 Gives me an average of 7.345 seconds | ||
| Back to top | | ||
| cooper_sport |
| ||
| and my flaming MINI Registered Member #7 Joined: Mon Oct 03 2005, 11:00PMLocation: Bournemouth Posts: 1741 | Thought I would retest my 30-70 time since I've now had a new clutch/flywheel and seem to be hitting 18 psi everytime I go flat out. And to my surprise I'm getting much better times now. Got a few 5.9's and a 5.8. So average is about 5.86. Thats much better than the 6.32 I was getting before so I think my old clutch was on the way out. Forgot to add this time is also with my seats left in and GTT rear brace fitted. Outside temp was about 5c. [ Edited Tue Mar 04 2008, 09:49PM ] | ||
| Back to top | | ||
| Snowie |
| ||
  Registered Member #403 Joined: Tue May 15 2007, 11:00PMPosts: 14 | Mine is at 5.1 secs GP with JCM & GTT mods data from BigShows performance box. GP 1657 | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Thanks Alan Will update the post on here and M2. Damn thats quick though! MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Updated! MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| jamescalland |
| ||
Minimogel  Registered Member #346 Joined: Sat Feb 03 2007, 12:00AMLocation: Romsey Posts: 207 | Jus done mine over 3 runs: 1. 6.08 2.5.81 2.5.80 Avg 5.8secs 57 plate R56 Cooper s 236bhp ecu remap Cold air induction kit | ||
| Back to top | | ||
| SuperMini |
| ||
MiniStreetSleeper Registered Member #262 Joined: Mon Sep 18 2006, 11:00PMLocation: Eastbourne Posts: 44 | Hi there guys, I have MiniMania exhaust manifold de-cat, MiniMania fast road cam, Standard head, Standard intercooler, JCW injectors, Alta pannel filter, NGK iridium plugs, S uperchips custom re-map, JanSpeed cat back exhaust. And im making 263bhp @ 7500rpm (i know very high) and 210ft lbs torque and 4616rpm Today i did 30-70 in 3rd in 5.6 seconds as an average. Some of you may recognise this info from Mini2 Alex | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Hi Alex! Great work! Sorry to hear about what happened over on Mini2. Will add you to the list shortly MINI Project Loon : MINIProject.co.uk | ||
| Back to top |
| ||
| SuperMini |
| ||
| MiniStreetSleeper Registered Member #262 Joined: Mon Sep 18 2006, 11:00PMLocation: Eastbourne Posts: 44 | cheers mate, i am a bit gutted though i have to admit. they have even gone to the length of banning my i.p address to their site. But in all fairness i should have thought about what could happen before i acted, i also posted that thread, and then saw a post from some1 about what had happened with BigShow300. so i shot myself in the foot before i knew what the out come would be. Alex | ||
| Back to top | | ||
| Snowie |
| ||
| Registered Member #403 Joined: Tue May 15 2007, 11:00PMPosts: 14 | Hi Alex Sorry that you caught caught up in the mess yesterday - it just shows how important it is to realy think before posting. A few other good people also left yesterday. GP 1657 | ||
| Back to top | | ||
| SuperMini |
| ||
| MiniStreetSleeper Registered Member #262 Joined: Mon Sep 18 2006, 11:00PMLocation: Eastbourne Posts: 44 | really? who also left? i know 1320autos have. Alex | ||
| Back to top | | ||
| Dave |
| ||
| Registered Member #140 Joined: Mon Mar 13 2006, 12:00AMLocation: Southampton Posts: 4619 | Guys, PM eachother MINI Project Loon : MINIProject.co.uk | ||
| Back to top | | ||
| Go to page >> | |
Powered by e107 Forum System
.JPG)
.JPG)